Glow-worm Clearly Solar Vertical In-Roof Collector User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
17
Diagram 6.2
15190
Roof Requirements
Refer to the diagram and table below and conrm the roof
requirements before installation.
IMPORTANT
Do not remove the protection lm until the system is to be
commissioned.
With due regard to the complete weight of the solar
collector system, (refer to technical data) ensure the
roof rafters and battens are in good condition and have
sufcient load carrying capacity and the battens are
secure.
If you are using the existing roof battens for xing, ensure
that they are secured at each rafter.
6.1 Installation
NOTE: Ensure adequate provision has been made for the
ow and return pipes to enter/exit the roof space, dependant
on their location. The preferred hydraulic scheme will
determine their location, refer to Section 3.
Refer to diagram 6.1 and check the contents of the kits prior
to commencing work on the roof.
Based on the dimensions, above, remove the roof covering.
Fix the lower ashing support batten, see diagram 6.2.
Position the left lower ashing onto the roof batten and secure
with six securing screws (no.1), with Torx bit supplied, see
diagram 6.3.
Slide the right lower ashing up to the mark on the left lower
ashing, see diagram 6.4. Screw the right lower ashing onto
the roof batten and secure with six securing screws (no.1) and
Torx bit supplied.
6 Two Collector Flashing Kit - 22
0
- 75
0
A
B
No.1
2380
Diagram 6.3
14938
3336
2725
A
150
Distance ‘A must
be between 280mm
and 309mm. Use an
additional batten if
required
The bottom
flashing is fixed
to this (original)
batten
Additional
batten to
support the
collector
Additional batten
for securing the top
flashing fixings
LOWER FLASHING
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comments to this Manuals

No comments