Glow-worm Micron 50FF User Manual download pdf (Page 11)

2000225227C

Diagram 4.3

9351

Diagram 4.4

MOUNTING

BRACKET

SECURING

SCREW

WALL

PLUG

7317

MOUNTING

BRACKET

FIXED TO BOILER

WALL

PLUG

4 Flue and Appliance Preparation

NOTE: Make sure that the ductings do not slope down towards

the boiler.

4.1 Flue Position and Length

Determine flue application, length and terminal position before

starting.

Refer to diagram 4.1.

If you are using a Flue Bend or a Vertical Flue Kit, please follow

the instructions supplied with the kit.

To make a neat finish to the flue outlet a flue collar kit, part No.

900850, with instructions, is available, see diagram 4.2.

Note: If required an optional wall liner kit, part no. 900862, is

available complete with instructions.

4.2 Flue Preparation

All flue assemblies are designed for internal installation, given

that there is sufficient clearances opposite to the flue for the

installation of the flue.

If there is insufficient clearance the flue can be installed from

outside.

For a wall thickness up to 300mm, provided that there is

sufficient space and the optional wall liner kit is used, the flue

can be installed from the inside.

For a wall thickness of over 300mm the external flue hole will

need to be made good from the outside, this also applies if you

use the flue kit without the optional wall liner kit, irrespective of

wall thickness.

4.3 Rear, Top and Side Flue Application

Select the boiler location and flue application, with due regard

to the terminal position, see diagram 2.1.

Take the template from the boiler pack and temporarily position

it on the wall, making sure that the minimum clearances are

maintained, see diagram 4.3.

Mark the centre line position of the flue, "Top" or "Rear" as

diagram 4.3.

For a side flue, extend centre line of "Top" to L.H. or R.H. corner.

Mark the position of the centre of the flue and boiler, as

diagram 4.3.

4.4 Flue Hole Cutting

Having marked out the flue centre cut a hole for the flue using,

preferably, a 115mm minimum core drill.

4.5 Wall Mounting Bracket

Reposition the template, making sure of dimensional alignment

with the flue hole.

Mark the boiler fixing points and mounting bracket positions,

see diagram 4.4.

Drill the holes and insert wall plugs.

Note : The lower mounting bracket is fixed to the boiler.

Secure the top mounting bracket to the wall with two No.12x2in

wood screws one on each side of the bracket, see diagram 4.4.

Alternative fixing positions are provided in the bracket, if required.

4.6 Flue Duct

Extend the telescopic flue to the required length, making sure

that the minimum overlap is no less than 25mm, and that the flue

terminal projects 15mm minimum beyond wall face, see diagram

4.1.

Diagram 4.2

7148

OPTIONAL

FLUE

COLLAR

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Glow-worm Micron 50FF User Manual Page 11

Comments to this Manuals

Related products and manuals for Water boiler Glow-worm Micron 50FF